Trumpf 1604786, Инструкция по эксплуатации, Страница: 26 / 110

Unpacking and Setting up the Operating Table
26
Instruction manual Operating table TruSystem 7000 – 1 730 263 – 11/2016
3 Unpacking and Setting up the Operating Table
The operating table is delivered on a pallet, in a packing case.
Ordered table components/accessories are packed individually
on the pallet, or are connected to the operating table. Warning, the
packaging is not weatherproof. Follow the ambient conditions for
storage and transportation (shipping) in the section 24 on page 96.
Unpack the operating table in a room with a level floor and
sufficient open space to roll away the pallet.
1. Position the pallet so that an area of approx. 5‘ x 16‘ 6”
(1.5m x 5 m) is available.
2. Open the top of the box.
3. Lift the two-piece ramp up and out and position it at the front
edge of the pallet as shown.
4. Remove the box fasteners below at the pallet.
5. Lift the box upward and remove it.
6. Remove the scope of delivery notice.
7. Take off the straps.
8. Remove the securing beams.
10. Switch on the operating table using the column keypad (press
the O
N
key).
11. Remove key lock. To do this, press the K
EY RELEASE
key. The
release of the keypad is indicated by an acoustic signal and
the associated indicator lights up. The keypad is released for
operation for 10 seconds.
9. NOTICE
Risk of material damage to the electronics due to
condensation.
There is a risk of condensation forming during transport, which
could potentially damage electronic components. After
delivery of the operating table, it is important to wait a certain
period of time before it is switched on or connected to an
external power source (at least 12 hours is recommended).
Place the operating table in an environment with the same
ambient temperature and relative humidity as the room where
the table will be used (see section 24.1 on page 96).