9.
Push the heat exchanger further into the AHU
casing unit until the tip of the heat exchanger
touches the sealing sheet at the back.
10.
Install the two brackets (1) and the front sealing
sheet (3).
If you removed the intermediate panels (2) earlier,
you now have to re-install them.
11.
Install the frame sections (1).
12.
Install panel and doors.
ð
Installation of the plate heat exchanger is com-
plete. You can now install the adjacent AHU
casing units.
Installing the actuator on the bypass damper of the
plate heat exchanger
Materials:
Actuator with clamping device and anti-twist facility
Preparation:
Turn the actuator as far as it goes, i.e. up to the
travel stop.
Close the bypass damper manually.
Fig. 18: Preparing installation
1.
On the bypass damper of the plate heat
exchanger break off the metal cover strip (1) on
the mullion between the dampers and remove the
screws (2).
Setup and assembly
Setting up and assembling the air handling unit > Installing the plate heat exchanger
Air handling unit X-CUBE
34
