Trox Technik X-CUBE Ex, Руководство по транспортировке и установке

Страница: 9 / 160

Safety shoes
Safety shoes protect the feet against crushing, falling
parts, and from slipping on slippery ground.
Explosion protection
WARNING!
Explosion hazard from electrostatic charges!
If you have to work in areas with potentially explosive
atmospheres, make sure that no electrostatic charge
is built up on non-metallic parts and induced in your
body.
To avoid electrostatic charges:
– Wear anti static clothes, shoes, gloves etc.
– For tools, comply with EN 1127-1, appendix A.
The work area should ideally have anti static flooring.
2.4 Residual risks
Suspended loads
DANGER!
Danger of death due to suspended loads!
Falling loads may cause serious injury or death.
Therefore:
– Never walk under suspended loads.
– Only move loads under supervision.
– Observe the specifications for the intended
lashing points.
– Do not attach the lifting gear to protruding
machine parts or lugs on attached components
– Ensure that the lifting gear is secure.
– Only use approved hoisting devices and lifting
gear with with sufficient load-bearing capacity.
– Do not use any frayed or worn ropes and belts.
– Do not place ropes or belts near sharp edges or
corners; do not knot or twist.
– Place the load on the ground before leaving the
workplace.
Industrial trucks
WARNING!
Danger to life from industrial trucks!
Objects and other loads could fall in an uncontrolled
manner from industrial trucks during transport and
cause serious injuries or even death. There is also
the risk that people will not be seen and could thus
be run over by the vehicle driver.
– Industrial trucks may only be operated by trained
vehicle drivers (e.g. forklift drivers).
– People should only pass industrial trucks when
the vehicle driver has signalled that they have
seen them.
– Only approved industrial trucks with sufficient
load-bearing capacity may be used.
– Materials should never be transported in the
vicinity of people or the zones occupied by
people.
Electric current
DANGER!
Danger of death due to electric current!
Danger of electric shock! Do not touch any live com-
ponents! Damaged insulation or damaged parts are
a life threatening hazard.
– Have work on the electrical system carried out
only by skilled qualified electricians.
– Have work on the electrical system carried out
only by skilled qualified electricians.
– If the insulation is damaged, disconnect the
power supply immediately and have the insula-
tion repaired.
– Before you start working on electric systems and
equipment, switch off the supply voltage and
secure it against being switched on accidentally.
Comply with the 5 safety rules:
–
Disconnect.
– Secure it against being switched on acciden-
tally.
– Ensure that no voltage is present.
– Connect to the earth; short circuit connection.
– Either cover nearby parts that carry a voltage
or install barriers.
– Do not bypass or disable any circuit breakers. Be
sure to maintain the correct current rating when
you replace a circuit breaker.
– Ensure that live parts do not come into contact
with moisture. Moisture can cause a short circuit.
Safety
Residual risks
Air handling unit X-CUBE Ex 9