Trox Technik X-CUBE Ex, Руководство по транспортировке и установке

Страница: 124 / 160

2 Installation
2.1 Installing the exchanger blocks
■ Prepare block no. 1 (flattened corner at the bottom).
■ Apply the sealing compound in the sealing groove that runs around the block.
■ Attach block no. 2.
■ Use rivets to connect the flanges of the side walls to one another.
■ Attach angle brackets 1-2 (inside and outside):
– Place the bracket onto the corner sections in the middle of the exchanger.
– Drill holes and insert rivets.
■ Rotate blocks 1 and 2.
■ Apply the sealing compound in the sealing groove that runs around block no. 2.
■ Attach block no. 3.
■ Use rivets to connect the flanges of the side walls to one another.
■ Attach angle brackets 2-3 (inside and outside).
■ Apply the sealing compound in the sealing grooves that run around blocks 1
and 3.
■ Attach block no. 4.
■ Use rivets to connect angle brackets 3-4 and 4-1 to the corner sections.
1-2 1-2
1-2
1-2
2-3 2-3
3-4
4-1
Fgi. 2: Installation sequence and position of the angle brackets
Fgi. 5: Rivet on the angle brackets Fgi. 3: Apply sealing compound
Fgi. 4: Rivet the side wall flanges to one another
Installation of compound
plate heat exchangers
Art. No. 4 212 499-en-00 / Page 2
Supplier documents
Air handling unit X-CUBE Ex 124