Triumph Speed Triple R, Руководство пользователя

Страница: 51 / 148

General Information
51
System Display
1. TPMS symbol
2. Front tire, identified
3. Rear tire, identified
4. Tire pressure display
5. Button A
6. Button B
To access the tire pressure display, turn
the ignition to the ON position.
Press and release button 'A' until PSI or
bAR is shown in the display screen.
Press and release button 'B' to select
the front or rear tire pressure.
When the tire pressure monitoring
system has been selected, —— PSI or
bAR will be shown in the display screen
until the motorcycle is traveling at a
speed greater than 12 mph (20 km) and
the tire pressure signal is received.
To exit the tire pressure display, press
and release button 'A' to the desired
display.
Sensor Batteries
When the battery voltage in a pressure
sensor is low, LO bAt will be displayed
and the TPMS symbol will indicate which
wheel sensor has the low battery
voltage. If the batteries are completely
flat, only dashes will be shown in the
display screen, the red TPMS warning
light will be on and the TPMS symbol will
flash continuously. Contact your
authorized Triumph dealer to have the
sensor replaced and the new serial
number recorded in the spaces provided
on page
50 .
1. TPMS symbol
2. Front tire, identified
3. Rear tire, identified
4. TPMS warning light
5. Tire pressure display
With the ignition switch turned to the
ON position, if the TPMS symbol flashes
continuously and the TPMS warning
light remains on there is a fault with the
TPMS system. Contact your authorized
Triumph dealer to have the fault
rectified.
Warning
Do not attempt to switch between
front and rear tire display modes with
the motorcycle in motion as this may
lead to loss of motorcycle control and
an accident.
1 2
4
3
5
6
TC
TC
1 2 3 4
5