TrimTrac ProE Locator, Техническое руководство

Страница: 151 / 233

TrimTrac ProE Locator Technical Manual v2.0e 133
AT+CTKY?
CTKY: <HPA Idle Timeout, T11>,<MPA Idle Timeout, T12>,<HPA Delay
Timeout, T13>,<MPA Delay Timeout, T14>,<HPA Transmit Timeout,
T15>,<MPA Transmit Timeout, T16>,<HPA Query Timeout, T17>,<HPA
Transmit Attempts, N5>,<MPA Transmit Attempts, N6>,<LPA Transmit
Attempts, N7>,<HPA Mode>,<MPA Mode>,<LPA Mode>
OK
<HPA Idle Timeout,
T11
> In Seconds (10-999990). Default
10
<MPA Idle Timeout,
T12
> In Seconds (10-999990). Default
10
<HPA Delay Timeout,
T13
> In Seconds (10-86400). Default
10
<MPA Delay Timeout,
T14
> In Seconds (10-86400). Default
10
<HPA Transmit Timeout,
T15
> 0=Infinity; Else in Seconds (10-999990). Default
0
<MPA Transmit Timeout,
T16
> 0=Infinity; Else in Seconds (10-999990)
If not set 0-
Infinity, should be set no lower than 300 Seconds
.
Default
300
<HPA Query Timeout,
T17
> In Seconds (10-3600). Default
60
<HPA Transmit Attempts,
N5
> 0=Until T15 Expires; 1-255=Number of Tx
Attempts
before T15 expires. Default
0
<MPA Transmit Attempts,
N6
> 0=Until T16 Expires; 1-255=Number of Tx
Attempts
before T16 expires. Default
0
<LPA Transmit Attempts,
N7
> 0=Until T3 Expires; 1-255=Number of Tx
Attempts
before T3 expires. Default
0
<HPA Mode>
0=Automatic; 1=Disabled;
2=Network
Acknowledgement; 3= Monitor-only
. Default
0
<
MPA Mode
>
0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only.
WARNING:
Before inserting a Vehicle
Adapter or Control Module:
A) Connect the red (+) and black (-) wires to a
9-32 VDC power source and install a 100k
Ohm resistor across the yellow wires; OR
B) Return MPA Mode to its default setting
“1=Disabled”.
. Default
1
.
<LPA Mode>
0=Automatic; 1=Disabled;
2=Network
Acknowledgement; 3= Monitor-only
(regardless
of motion)
. Default
0
Table 46, AT+CTKY? Query