TRENDnet TEW-659BRN, Руководство пользователя

Страница: 46 / 97

© Copyright 2012 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-659BRV
43
Router A Configuration
1. Log into your router management page (see “Access your router management page”
on page 50 ).
2. Click on
Configuration at the top of the page, click on Security Setting , and click on
GRE Tunnel .
3. Review and configure the GRE Tunnel settings:
• Name – Enter a name for the tunnel (e.g. Tunnel1)
Note: Do not use spaces in the name. The name must match on both routers.
•
Tunnel IP – Enter the tunnel virtual IP address.
(e.g. 1.1.1.1)
•
Peer IP – The remote WAN (Internet) IP address of your router.
(e.g.
10.10.10.10)
• Key – Enter the key for the tunnel . (e.g. 12345)
Note:
The value 12345 is shown as an example. It is strongly recommended to
enter your own key. Write down the key you enter as it will also need to be
entered when configuring Router B. The preshared key can consist of up to five
alphanumeric characters (a,b,C,?,*, /,1,2, etc.)
• TTL – Enter the Time to Live value. (Range 1-255, Recommended: 100)
• Subnet
– The remote LAN IP subnet/netmask in CIDR (Classless Inter-Domain
Routing) notation or network of your remote router.
(e.g. 192.168.100.0/24
where the /24 represents 255.255.255.0 subnet mask)
• Enable – Check this option to enable the tunnel.
Based on the example, the GRE settings will be the following:
4. Click
Save at the bottom of the page to save the changes.
Note:
If you would like to discard the changes, click
Undo
before you click
Save
. If you
are prompted to reboot, reboot the device to apply the changes.
Router B Configuration
1. Log into your router management page (see “Access your router management page”
on page 50 ).
Note: If you changed router LAN IP address, you will need to log into the remote router
using the new IP address instead of the default 192.168.10.1.