TRENDnet TEW-659BRN, Руководство пользователя

Страница: 51 / 97

© Copyright 2012 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-659BRV
48
Review the outbound packet filter settings.
•
Source IP – Enter the source IP address or computer/device IP address on your
local network to apply the filter.
(e.g. 192.168.10.101)
• Destination IP : Ports – Enter the destination IP address of the
computer/device located on the Internet and port number to apply the filter.
To specify all port numbers, do not specify any value for Ports field. For specific
port numbers, enter a port number or range within the range of 1-65535
(e.g.
21 or 21-30)
in the Ports field.
Note: Typically, you can specify 0.0.0.0 for any destination IP address located on
the Internet or enter the specific IP address. (e.g. 10.10.10.200)
•
Protocol – Select the protocol type to filter. TCP, UDP , or you can select Both
to choose both protocol types .
• Enable – Check the option to enable the filter.
• Use rule# -
Click the drop-down list to select a pre-defined schedule. The filter
will only be active during the time period defined in the pre-defined schedule.
Note: Before applying scheduling, please ensure your Time settings are
configured correct and you have defined a schedule. See page 51 to configure
Time Settings and see page 65 to create a schedule.
To save changes, click Save at the bottom of the page.
Note: If you would like to discard the changes, click Undo before you click Save .
Clicking MAC Level will bring you to the MAC Control configuration page. See MAC
Control section.
Inbound Packet Filter
You may want apply inbound packet filters to allow or deny access of specific traffic
from the Internet to computers or devices on your local network.
To configure inbound packet filters:
Click
Inbound Filter at the bottom of the outbound packet filter page.
Next to
Inbound Packet Filter , check the Enable option to enable inbound filtering.
• Select Allow all to pass except those match the following rules to allow all
traffic and deny only the filters specified in the list.
•
Select Deny all to pass except those match the following rules to deny all
traffic and allow only the filter specified in the list.
Review the inbound packet filter settings.
• Source IP – Enter the source IP address or computer/device IP address on your
located on the Internet to apply the filter. (e.g. 192.168.10.101)
Note:
Typically, you can specify 0.0.0.0 for any source IP address located on the
Internet or enter the specific IP address. (e.g. 10.10.10.200)