TP-Link L-R480T+, Руководство пользователя

Страница: 13 / 131

-7-
LED Status Indication
Off
The linked device is running at 10Mbps or no device linked to
the corresponding port.
100Mbps
(WAN/LAN)
On (Green/Yellow)
The linked device is running at 100Mbps. (Green light
indicates the corresponding port is working as a LAN port, and
yellow indicates WAN port.)

Interface Description
Interface Port Description
WAN 1–4 The WAN port is for connecting the router to a DSL/Cable modem or
Ethernet by the RJ45 cable.
LAN 2–5 The LAN port is for connecting the router to the local PCs or switches
by the RJ45 cable.
Console /
The Console port is for connecting with the serial port of a computer or
terminal to monitor and configure the router.

Reset button
Use the button to restore the router to the factory defaults. With the router powered on, use a pin to
press and hold the Reset button (about 5 seconds). If the SYS LED is flashing 5 times in high frequency,
release the Reset button. It means the router is restored successfully. The default management address
of the router is
http://192.168.0.1 , and the default username and the password are both admin .
2.3.2 Rear Panel
The rear panel of TL-R480T+ is shown as the following figure.

AC Power Receptacle
Connect the female connector of the power cord to this power receptacle, and the male connector to the
AC power outlet. Please make sure the voltage of the power supply meets the requirement of the input
voltage (100-240V~ 50/60Hz).

Grounding Terminal
The router already comes with lightning protection mechanism. You can also ground the router through
the PE (Protecting Earth) cable of AC cord or with Ground Cable.
Note:
Please only use the power cord provided with this router.