TOYOTA
LAND CRUISER
2010 -
TVIP V4
Procedure
REMOTE ENGINE STARTER (RES)
Page 13 of 27 pages
Issue: C 08/19/10
(m)
Attach 1 Large Foam Tape to the Vehicle’s
Brace and the V4 Harness as shown. Then
put the Carpet back. (Fig. 3-9)
GO BACK TO THE V4 HARNESS’S
WHITE TAPE MARKER AREA.
4.
Gateway ECU Preparation and Installation.
(a)
Insert the Gateway ECU Bracket into the
indicated Bracket Slots on the Gateway
ECU. (Fig. 4-1)
(1)
Ensure the Bracket is firmly attached to the
ECU.
(b)
Connect the V4 Harness's White 5P
Connector to the Gateway ECU. (Fig. 4-2)
(1)
Verify secure connection.
(c)
Using the M6 Tapping Screw from the Kit,
install the Gateway ECU Bracket. (Fig. 4-2)
(1)
Make sure that the Bracket Pin seats properly.
CAUTION:
Do not crimp the V4 and/or the V2
Harness between the Gateway ECU Bracket and
the Vehicle Reinforcement Brace.
Fig. 3-9
RES ECU
Carpet
Large Foam Tape
Vehicle’s Brace
Fig. 4-1
Connector
Gateway ECU
Gateway ECU Bracket
Fig. 4-2
10mm Socket
Gateway ECU
5P
Tapping Screw
V4 Harness
Pin
Hole
