TOYOTA
LAND CRUISER
2010 -
TVIP V4
Procedure
REMOTE ENGINE STARTER (RES)
Page 24 of 27 pages
Issue: C 08/19/10
(g)
Use Household Glass Cleaner to clean the
inside of the Front Door Window. (Fig. 8-4)
(h)
Use a piece of Clear Tape to lift the Label
off its protective backing.
CAUTION:
Do not touch the adhesive surface.
(i)
Attach the Label as shown. (Fig. 8-4)
NOTE:
Make sure to Align according to
Etching or Other Label. (Fig. 8-4)
REPEAT:
steps g–i with the other Window.
9.
Completing the Installation.
(a)
Cut and apply
⅓
piece of Large Foam Tape
to the backside of the Glove Box as shown.
(Fig. 9-1)
(b)
Complete the reassembly of the Vehicle.
(1)
Verify the Panels fit together properly, with no
uneven gaps.
(c)
Position the Negative Battery Cable at the
original factory position. (Fig. 9-2)
(1)
Tighten the Nut to 36 in•lbf (4.07 N•m)
CAUTION:
Do not touch the positive terminal.
(d)
Clean up and remove any Trash.
(e)
Sealed in its protective Bag, place the
Owner’s Guide in the Glove Box.
(f)
Reset the power windows.
(1)
Press the Power Button to select the Ignition
“ON” position.
(2)
Push down on the Power Window Switches
lowering the windows halfway.
(3)
Pull up on the switches until the windows close
(4)
Continue holding up on the Switches for a
minimum of 1 second.
Fig. 9-2
Negative Battery
Cable
Torque Wrench
Battery
Fig. 9-1
⅓
Foam Tape
Glove Box (backside)
Utility Knife
Large Foam Tape
Molding
Etching
Etching
Molding
Clear Tape
Fig. 8-4
