TOYOTA
LAND CRUISER
2010 -
TVIP V4
Procedure
REMOTE ENGINE STARTER (RES)
Page 8 of 27 pages
Issue: C 08/19/10
VEHICLES EQUIPPED WITH
NAVIGATION SYSTEM.
(p)
Remove the DVD Unit from the Glove Box
Area. (Fig. 1-15)
(1)
Remove 2 Screws and 1 Nut.
(2)
Using the Clip Clamp Tool or the like, push on
the inside the Vehicle Clamp, and release it
from the DVD Unit.
2.
V4 Wire Harness Installation.
(a)
Route the V4 Harness behind the Vehicle
Brace and Yellow Harness in the Glove
Box area as shown. (Fig. 2-1)
CAUTION:
Sharp metal edges.
(b)
Secure the V4 Harness's White Taped
Marker to the Reinforcement with 1 Wire
Tie. (Fig. 2-2)
(c)
Secure the V4 Harness to the
Reinforcement with 2 Wire Ties.
(Fig. 2-2)
(d)
Locate and remove 1 Bolt from the Vehicle
Ground Terminal in the upper left side of
the Glove Box Area. (Fig. 2-3)
(1)
Do not discard the Bolt.
Fig. 2-3
Bolt
Vehicle’s Ground Terminal
10mm Socket
V4 Harness’s Ground Terminal
Fig. 1-15
10mm Deep Socket, Clip Clamp Pliers, Screwdriver
Nut
Screw
Screw
DVD Unit
Clamp
Side Cutter
Fig. 2-2
5P
V4 Harness
V4 Harness’
White Tape
Marker
Wire Ties (x3)
Fig. 2-1
Vehicle’s Yellow Harness
Brace
V4 Harness
V4 Harness
White Tape
