TOYOTA
LAND CRUISER
2010 -
TVIP V4
Procedure
REMOTE ENGINE STARTER (RES)
Page 12 of 27 pages
Issue: C 08/19/10
(g)
Connect the V4 Harness's White 20P
Connector to the RES ECU. (Fig. 3-6)
(h)
Using the VDC approved cleaner and
Cleaning Method, clean the area indicated
on the left side of the Passenger’s Side
Floor. (Fig. 3-6)
(i)
Remove the Protective Sheet of the Double
Stick Tape. (Fig. 3-6)
(j)
Center the RES ECU Bracket to Vehicle's
Bolt as shown. Then press the RES ECU
firmly to the Vehicle. (Fig. 3-6)
(1)
Do not attempt to reposition the ECU once
placed.
(k)
Run 1 Extra Large Wire Tie through the
RES ECU rectangular hole and behind the
Vehicle Brace and secure it. (Fig. 3-7)
(1)
Do not tighten the Wire Tie, it should hang
freely.
(l)
Secure the V4 Harness to the side of the
inside Vehicle Brace with 1 Wire Tie as
shown. (Fig. 3-8)
(1)
Do not use the front hole of the Vehicle Brace.
Fig. 3-6
Bolt
20P
V4 Harness
RES ECU
Portion of the
Protective
Bracket
Floor Carpet
Fig. 3-7
Side Cutter
V4 Harness
RES ECU
Vehicle’s Brace
ECU Bracket’s
Rectangular Hole
Extra
Large
Wire
Tie
Wire Tie
Side Cutter
V4 Harness
RES ECU
Vehicle’s Brace
Hole
Fig. 3-8
