TOYOTA
LAND CRUISER
2010 -
TVIP V4
Procedure
REMOTE ENGINE STARTER (RES)
Page 10 of 27 pages
Issue: C 08/19/10
(i)
Secure the 10P Connectors to the Vehicle
Harness with 1 Wire Tie. (Fig. 2-8)
(j)
Secure the V4 Harness to the Vehicle
Harness behind the Passenger's Side
Connector Block with 1 Wire Tie.
(Fig. 2-8)
(k)
Wrap the V4 Harness’s branch area with 1
Large Foam Tape as shown. (Fig. 2-9)
(l)
Route the V4 Harness's White 20P
Connector toward the Vehicle's Floor.
(Fig. 2-9)
3.
RES ECU Preparation and Installation.
(a)
Remove the Clear Protective Sheet from the
Double Stick Tape and attach it to the Part
Number Label side of the RES ECU as
shown. (Fig. 3-1)
(1)
Be sure to apply the Clear Sheet side on the
RES ECU.
(2)
Be sure to attach adhesive tape on the part
number label side of the RES ECU.
(3)
Do not cover the Part Number Label with the
adhesive tape.
CAUTION:
Do not touch the adhesive surface.
Fig. 2-8
10P Connectors
V4 Harness
Side Cutter
Wire Tie
Vehicle Harness
Wire Tie
Vehicle
Harness
Fig. 3-1
RES ECU
Double-Side Adhesive Tape
Part Number Label
Yellow Sheet
(Vehicle Side)
Clear Sheet
(RES ECU Side)
Fig. 2-9
V4 Harness
V4 20P (White)
Large
Foam
Tape
