19
❏
11. Mount the throttle servo in the servo tray and
slide a plywood pushrod support onto the outer
pushrod tube.
❏
12. Thread a 2-56 x 1" [25.4mm] threaded rod
approximately 3/8" [9.5mm] into the end of the white
inner pushrod tube. Thread a nylon clevis 14 turns
onto the end of the threaded rod. Slide a silicone clevis
retainer over the clevis. Inset the white inner pushrod
tube in the throttle's outer pushrod tube. Attach the
clevis to the throttle servo arm.
❏
13. Glue the plywood pushrod support so that the
pushrod is inline with the servo arm and on the outside
of the aft fuel tank support.
❏
14. Thread the nylon ball link socket 14 turns onto
the second 2-56 x 1" [25.4mm] threaded rod. Attach the
ball link socket to the ball link ball on the throttle arm.
❏
15. Position the throttle stick so that it is centered
on the transmitter. Adjust the throttle servo arm so
that it is centered on the throttle servo. Move the
throttle arm on the carburetor so that the throttle is
open approximately half way. Mark and cut the white
pushrod tube to length. Remove the ball link socket
from the throttle arm and thread it into the cut end of
the white pushrod tube. Reattach the clevis to the
throttle servo arm and the ball link socket to the ball
link ball. Make adjustments as needed so that the
throttle opens and closes completely.
❏
16. Install the choke servo, 2-56 x 1" (25.4 mm)
threaded rod, white inner pushrod tube and nylon
clevis following the same procedure used for the
throttle pushrod.
