Tomey TMS-5, Инструкция по эксплуатации

Страница: 87 / 216

3-37
● Angle
The specified angle is shown as the Angle value at the
top of the slit image (8) after setting Angle1 (or Angle2).
The unit is degrees (deg).Click a measurement point on
the image with Angle1 selected in the item list (11).The
point for Angle1 and 2 lines (20) drawn from that point
appear.The end points of these 2 lines can be dragged
and moved by the mouse.Both Angle1 and Angle2 can
be moved in the same manner.
To correct a measurement point after the above
operation is completed (or being conducted), check the
item to be corrected (11) and click the corresponding
point on the image again. Correction can also be made
by dragging the desired point to be corrected on the
image. Click the cursor button (12) with the desired item
(11) checked to move the corresponding point in fine
increments. Click the “CLEAR” button (13) to delete all
data displayed on the image.
Click the “Save” button (22) to save the information
displayed on the image.Click the “Load” button (21)
to read the information saved on the image from the
previous operation.
These slit images can be analyzed one by one.
● Display/hide trace lines on slit image
Click the “Trace” button to switch the display mode (ON/
OFF) for trace lines (green lines) on the slit image.
● Display brightness of slit image
The image brightness at the vertical dotted line (15)
on the slit image is shown in waveform (16). Place the
cursor (17) on the top of the dotted line and drag to
move the vertical dotted line.
● Correct color tone of slit image
The color tone of the slit image can be corrected in
the color tone correction area (18) (Fig. 2). Correction
values for “Grain,” “Brightness,” and “Contrast” can be
set using the corresponding slide bar (19).