69
MINI-STATION D‘ÉPURATION ENTIÈREMENT BIOLOGIQUE POUR LES PÉNICHES, LES YACHTS ET LES MAISONS MOBILES
enteron | Manuel d‘utilisateur
Normalement, il n’est pas nécessaire de changer l’heure système sauf si vous tra-
versez plusieurs fuseaux horaires. En ce cas, le temps de déconnexion nocturne
intégrée dans le système se déplace progressivement aux heures matinales, et le
réajustement doit être fait tous les 2 fuseaux horaires.
Si toutes les connexions sont effectuées correctement
et la station a été remplie à moitié d’eau, il peut être
mise en marche en activant la tension d’alimentation.
Le bon démarrage de la station est affiché par l’afficha
-
ge initial et
[AIR on]
(la pompe d’aération démarre).
Faites attention aux trappes d’inspection solidement
fixées. Ensuite, transvasez la pompe une fois en appuy
-
ant sur
[MA MAC]
sur la télécommande et
pompez une fois en appuyant sur
[MA OUT]
.
MISE EN SERVICE DE LA STATION ET TEST DE FONCTIONNEMENT
Une station d’épuration entièrement biologique nécessite 4 à 6 semaines de fonc-
tionnement continu jusqu’à ce que les performances de nettoyage correctes soi-
ent atteintes. La formation de la souche bactérienne et la croissance sur le trans-
porteur de bactéries dans le bioréacteur prend du temps. Néanmoins, la station
d’épuration répond à la norme pour l’eau désinfectée et sans sédiments depuis
le début, mais des décolorations peuvent apparaître jusqu’à la fonction correcte.
Vous pouvez accélérer cette phase de démarrage en obtenant des boues foisonn-
antes provenant d’une usine de traitement des eaux usées ou d’une autre station
d’épuration biologique. Celui-ci peut être versé directement aux toilettes dans un
bidon simple (5 l suffisent). Les bactéries qui y sont contenues sont déjà entière
-
ment développées et préparées pour le traitement de la matière fécale. Mais la
boue résiste seulement pour une courte période et devrait être alimentée en sys
-
tème dans un délai de 2 heures.
Après, rincez les toilettes plusieurs fois avec de l‘eau et
vérifiez l’étanchéité des raccords de tuyau. Si toutes les
connexions sont serrées, le système peut être mis en
service. Pour ce faire, mettez un sac de concentré de
bactéries dans les toilettes et attendez qu’il se dissolve.
Puis rincez, fini.