TMP High Performance Vector Control Inverter User Manual
33
4.4 Keypad Operating Status
4.4.1
Initialization after power on
When the power is switched on, panel will start 5 seconds’ initiation process. During this
process, LED displays "8.8.8.8.” , and all LED indicators on the panel are in ON state
4.4.2
Stopping State
In stopping state, LED displays default parameters in flashing mode, and the unit
indicator in right side displays the unit of this parameters. In this state, all status
indicators are OFF, press
►►
key ,LED displays fault code
“
n-xx
”
(xx=00-08),press
SET key
to enter and view the parameter; press
PRG
key to exit; and press
►►
key to
scroll through parameters in stopping state.
4.4.3
Running state
In stopping state, after receiving running command, the drive enters running
state. The LED and unit indicator display parameter and its unit respectively.
At this time, running status indicator is ON all the time. Press PRG key to
enter programming menu and view parameter value.
Press ►► key, LED displays running parameter “r-xx” (xx=00~14). Press
SET key to enter and view parameter value; press PRG key to exit this parameter
menu; press ►► key to scroll through monitoring parameters.
4.4.4
Fault alarm state
In stopping, running or programming state, correspondent fault information
will be reported if fault is detected. At this time, LED displays the fault code in
flashing mode. When fault alarm occurs, press PRG key to enter programming
menu and look up the fault log.
When fault alarm occurs, the alarm picture is displayed, and the fault can be
reset by press STOP/RESET key. The drive restores to normal operation upon
clearing the fault, and the fault code is displayed again if the fault has not been
cleared.