P14
MAinMenU
7.1.1.2newTP
This submenu allows adding one or more transponders to the database of the selected
satellite. This enables you to check the signal respectively adjust the antenna for this
satellite. Further you can perform a NIT Search on the new satellite once you have added the
appropriate TP. The full edit functions are available in the
Channel Search
menu. Here use the
pq
buttons to navigate.
Frequency
:
For entering the desired frequency use the
0~9
buttons.
Symbol rate
:
For entering the required symbol rate use the
0~9
buttons.
Polarization
:
Here the polarization can be changed with
tu
.
By using the
pq
buttons you can select
OK
to change or
Cancel
to discard.
After all settings are adjusted following to your system requirements, press
eXiT/soRTie
to leave this
menu. A message will inform about the changes, use the
pq
buttons to select
Yes
to save or
No
to
discard and confirm with
ok
. The receiver will return to the selection screen and you can continue.
In case you want to delete a desired satellite press the
GReen
button. If you want to delete all
satellites that have been setup use the
YeLLoW
button to do so. Once all settings are made,
press
eXiT/soRTie
to leave this menu.
noTe:
Whenever you want to add technical data for a new transponder we recommend to verify
these by websites like: www.lyngsat.com or www.kingofsat.net or you can refer to professional journals.
7.1.2channelsearch
Use this menu to perform an automatic, network or transponder channel search or to search
on all satellites that have been setup. Use
pq
to highlight the desired item and
tu
to change
settings. Below the settings you can find the search method selection.
Antenna:
Here you can change the antenna port via
tu
in case you have
configured more than one satellite.
Satellite:
Here you will see the according satellite which is assigned to the
antenna in above, you can only see the satellite(s) which has/have
been setup in
Antenna Setup
menu before.
Transponder list:
By using
tu
you can change between the transponders referring
to the selected satellite, you can also press
ok
to list up and
select with
pq
or
PG+/-
. Afterwards press
ok
to choose. Use
ReD
to
Edit TP
, with
GReen
you can
Delete TP
and with
bLUe
you can enter data for a new TP
Add TP
.
For the further procedure in
Edit TP
and
Add TP
see chapter
7.1.1.2AddTP
. In
Delete TP
a
message will be displayed to apply your changes, use
pq
to select
Yes
to apply or
No
to
cancel and confirm with
ok
.
Scan Mode:
Here you can decide for which channels you want to scan: Either
scan all channels
FTA & $
, for Free-To Air only
FTA
or use
CA
to
scan for scrambled channels only.
Channel Type:
TV & Radio
will scan for TV and Radio channels,
TV
for TV
channels only and
Radio
for radio channels only.
LCN:
With this option you can select if you want to search for LCN
channels
ON
or not
OFF
.
After these settings are adjusted for the desired scan process move to
Scan selected satellite
with
pq
and then select the search method via
tu
.
You can select between following procedures:
Scan selected satellite:
Will scan the selected satellite under the above given circumstances.
Search All Sat:
Will scan the setup satellites under the above given circumstances.*
Search TP:
Will scan the selected transponder under the above given circumstances.
Network Search:
Will scan the selected satellite under the above given circumstances,
but will scan for new appeared transponders there.
