Theta Digital Casablanca IV, Руководство пользователя

Страница: 83 / 97

82
STATUS Display
This display, accessible from the hand held remote and viewed on the VFD, provides the user with a ‘quick view’
of the most pertinent current settings of the Casablanca IV as well as information about a Dolby Digital source.
The status page is available from any menu or submenu simply by pressing the
STATUS button.
When the STATUS display is activated, its title is displayed in the upper left corner along with the following:
•
The current INPUT SELECT BUTTON NAME .
•
The current mapped input jack.
•
The MODE .
•
The TAPE OUT audio source.
•
The PHASE parameter value ( 0
°
or 180
°
)
•
The Sample rate ( S RATE ) of the currently selected source.
•
The MASTER VOLUME level.
Press the A-D button once to display the status of the current Dolby Digital source. Press A-D once more to
display the status of the current DTS source.
Note that a Dolby Digital or DTS source needs to be playing in order to display the correct values on these status
pages.
Please refer to page 78 for additional information pertaining to Dolby Digital Status menu and page 79 for the DTS
Status menu.
Pressing the STATUS button once will clear the status display. Pressing a function button will clear the status
display and show that menu.
MODE Function
This function allows the user to audition MODE s for the currently selected input. Storing a default MODE is
done in the SETUP / INPUT
page 1
submenu.
Pressing the
MODE button once displays the first page of the MODE menu. This page consists of 6 different
signal processing modes, one of which can be selected and temporarily applied to the current input.
Please refer to page 62 for additional information regarding Dolby Digital options, page 65 for additional
information regarding DTS.
* * *
After selecting a temporary mode for the current input, press the MODE button once more to clear the video
monitor. The MASTER VOLUME can be controlled using the LEVEL UP / DOWN buttons in these 3 menus.
Default Mode
Each INPUT SELECT button can have a different default MODE assigned to it. To assign a default MODE for
a given INPUT SELECT button, first press the applicable INPUT SELECT button, SETUP , INPUT then button #
4 ( MODE ). Use the LEVEL UP/DOWN buttons to edit this parameter and select the desired default MODE .
Press SETUP twice to exit. Repeat this procedure for each INPUT SELECT button.
Note : Pressing the front panel MODE function button allows the user to audition different modes for a given
source, when applicable, however changing modes via the MODE button does not store a mode selection.