Thermo Scientific AI 3000, Руководство по эксплуатации

Страница: 71 / 108

3
Installation
Installation of the AI 3000/AS 3000 II on the GC
Thermo Scientific AI 3000/AS 3000 Sampling System - Operating Manual 53
2. By using the cable provided, connect the 9-pin female connector marked RS232 located
on the sampling unit back side to 9-pin connector marked AUTOSAMPLER located on
the GC rear panel.
3. In case of AS 3000 , connect the 15-pin female connector of the cable coming from the
support plate of the 105-position sample tray to the connector marked TRAY located on
the sampling unit back side.
Gemini Configuration
Figure 48 shows how to connect two AI 3000/AS 3000 II in Gemini Configuration.
Figure 48. Connections in Gemini Configuration
Proceed as follows:
1. By using the cable provided, connect the 4-pin male connector marked TWIN SYNC ,
on the rear of the sampling unit of the sampler “ a ”, to the 4-pin male connector marked
TWIN SYNC on the rear of the sampling unit of the sampler “ b ”.
2. By using the Y shape cable provided, connect:
a. the 6-pin female connector marked GC located on the sampling unit back side and
the connector, located on the rear panel of the GC, marked:
– AUTOSAMPLER HANDSHAKE in the case of TRACE 1300/TRACE 1310.
– SAMPLER SIGNAL in case of TRACE GC Ultra and FOCUS GC.
b. the first branch of the cable, labelled AI/AS 1 to the 6-pin female connector marked
GC on the rear of the sampling unit of the sampler “ a ”.
c. the second branch of the cable, labelled AI/AS 2 to the 6-pin female connector
marked GC on the rear of the sampling unit of the sampler “ b ”.
3. By using the Y shape cable provided, connect:
a. the 9-pin main connector to a PC serial port (e.g. COM 1) or to an USB port,
interposing a proper adapter not provided.
24 Vdc
-
+
TRAY
TWIN
SYNC
RS 232 GC
24 Vdc
-
+
TRAY
TWIN
SYNC
RS 232 GC
GC
PC
SAMPLER SIGNAL
COM 1
AI/AS 3000 (a)
AI/AS 3000 (b)