32
Fabricating Refrigeration Hoses (continued)
Oil the Nipple
3.
Lubricate the nipple with a generous amount of the Alkyl Benzene refrigerant oil (670404TKA). This MUST be done to
lower the force of nipple insertion.
4.
Insert the nipple into the hose. To ensure that the nipple is fully inserted, check the gap between the cut end of the
hose and the shoulder on the nipple. Care should be taken to avoid kinking or other damage to the hose during
nipple insertion.
NOTE: Be sure to wipe excess oil from the nipple and hose
.
Snap on the Cage
5.
Snap the cage into the groove on the nipple. The arms should extend over the hose length. When the cage has been
carefully installed in the cage grove, the cage will be able to rotate in the grove. This step must be performed to
ensure:
a.
The clips will be located over the O-ring on the nipple.
b.
The connection will be compatible with the connection’s pressure rating.
Slide the Clips
6.
Slide the clips over the cage arms and into the channels on each arm.
Close the Clips
7.
Use the fitting tool (204-1045 or 204-1128) to close the clips. The pliers should be positioned squarely on the
clip connection points and should remain square during the closing of the clip
.
NOTE: For easiest assembly, the clasp should be closed between the cage arms.
Содержание TriPac Envidia
