Thermo King TriPac Envidia, Руководство по установке

Страница: 53 / 80

51
Heater Fuel Pickup Tube Installation (Heat Option)
Direct Tank Installation – No Drilling
OEM Fuel Tank Fittings
DANGER: Use caution when working in or around the area of the diesel fuel tank. Diesel fuel vapors are potentially
explosive. Do not smoke while working near the diesel fuel tank.
NOTE: Some fuel tanks may have auxiliary fuel connections or 1/4" NPT connections factory installed. These
fitting eliminate the need to drill into the fuel tank to install the heater’s fuel pickup tube.
•
OEM Fuel Connections - Route and connect the heater’s fuel supply line to one of these fittings.
•
OEM 1/4" NPT Fitting - See following installation instructions.
Special Tools Required
Tape Measure
Tubing Cutter
Important Installation Tips
•
Remove the protective cap from the end of the pickup tube prior to installation.
•
Do not apply any type of sealant material to the fuel pickup tube assembly. Doing so will result in plugged fuel
lines.
Installation
NOTE: The tank mounted fuel pump bracket cannot be used on direct tank installations. The supplied
remote mounted L-bracket must be used.
1. Remove the nut, washers and bushing assembly from the fuel pickup tube as shown. The nut, washers and
bushing assembly will not be used.
2. Remove the 1/4" NPT fitting from fuel pickup tube and install it into the fuel tank’s 1/4" NPT fitting securely.
3. Measure the fuel tank diameter and cut the pickup tube 3” shorter.
4. Install the pickup tube with the ferrule nut into the tank.
a. Position the pickup tube as needed to facilitate fuel line connections and tighten ferrule nut securely.
5. Install the supplied warning nameplate onto the fuel tank in a visible area near the fuel cap.