Thermo King TriPac Envidia, Руководство по установке

Страница: 69 / 80

67
Operation Checkout Procedures
Overview
An operation checkout procedure must be performed after the TriPac Envidia installation has been completed. This procedure
will confirm the operation of the heating and air conditioning systems, and will verify the TriPac Envidia batteries are
charging and discharging properly. Any alarm codes that may have been set can also be checked and cleared. This checkout
procedure will be done in two steps:
Step 1 - Use the TriPac Envidia HMI controller to verify basic system operation.
Step 2 - Use a laptop PC connected directly to the TriPac Envidia Base Controller module using the Envidia Service
Tool and Service Test Mode to verify system operation in more detail.
The Envidia Service Tool communication software is service computer and will export information directly to a laptop PC.
This software provides the technician with system interface, flash load system upgrades, real time system information
retrieval, Service Test Mode and Alarm clearing capabilities.
The following tools will be required:
•
Laptop Computer (IBM Compatible).
•
USB Adapter Harness (204-2000 or USB Mini-B).
•
Envidia Service Tool software.
Step 1 – Checkout Procedures Using the HMI Controller
The following operation checkout procedures will be performed using the TriPac Envidia HMI controller.
NOTE: Make sure the tractor’s engine is off and ignition switch is in the off position.
1. Rotate Mode Selection knob to Fan Mode .
2. Rotate Temperature Selection knob so white dot is at the top.
3. Press Mode Selection knob for at least one second to turn the TriPac Envidia system ON.
a. Fan icon should flash for several seconds then stay on.
b. Evaporator fan may not start.
c. Battery level bars should illuminate steady green. It may take up to 30 seconds for the battery level bars to
illuminate steady green.
4. Rotate Fan Speed Selection knob clockwise .
NOTE: There will be a two second delay in response to changes made using the HMI Controller.
a. Fan speed LED indicators should increase.
b. Evaporator fan speed should increase.
5. Rotate Fan Speed Selection knob counterclockwise.
a. Fan speed LED indicators should decrease.
b. Evaporator fan speed should decrease.
6. Rotate Temperature Selection knob counterclockwise to the blue stop.