Manual operation with push buttons
Optical presence detector thePixa P360 KNX
54
6
Manual operation with push buttons
The detector can be overridden by using buttons or other higher-level commands. For this purpose, the separate
button input objects have to be used.
The manual operation only affects the light outputs. The HVAC and room occupancy outputs are not affected by
manual operation.
6.1
Manual operation via switching function without dimmable lighting
If the lighting is operated manually in function light <switch light..>, the following response occurs in the
corresponding zone:
Example with zone 1:
Push button operation
Response of lighting/detector
ON telegram
The lighting is switched on with an ON telegram of the
button. The override is detected via object 11, and the
lighting remains on for 30 minutes if the room is
occupied. Light measurement is deactivated.
The light measurement is reactivated after the 30
minutes. In case of sufficient brightness, an OFF
telegram is sent to object 10, and the lighting switches
off.
If the room is vacated before the 30 minutes have
expired, the light will be switched off normally after
the completion of the set time delays.
OFF telegram
The lighting is switched off with an OFF telegram of
the button. The override is detected via object 11, and
the lighting remains on for the duration of the
presence. After the room is vacated and the
corresponding time delay has expired, the zone is
again in normal switching mode.
