The application programme "thePixa P360 KNX"
Optical presence detector thePixa P360 KNX
23
5.3
Description of communication objects
5.3.1
General objects
Object 2: Temperature value - Send °C value
Sends the room temperature in °C, measured with the temperature sensor inside the device, as a 2-byte telegram.
The temperature value is adapted to the conditions in the room with the temperature calibration. The adaptation
can be done in thePixa Plug app.
Object available if "yes.." has been selected at <Send temperature on bus>.
Object 3: Central command - Receive
An ON telegram switches the lighting channels Z1 – Z6 on simultaneously and starts the <time delay after
presence>. The response is as if the user switches it on via button. The response depends on the selected control
An OFF telegram switches the lighting channels Z1 – Z6 according to the following conditions:
-
no motion when receiving the OFF telegram:
The light switches off immediately. The running time delays for lighting channels Z1 – Z6 and standby
time are set to 0. Afterwards, the detector is in normal operation.
-
If <Duration standby> is set to "on", the corresponding lighting channels are not switched off, but instead
switch to the set standby operation.
-
Motion when receiving the OFF telegram:
The light remains switched on.
Fully automatic device:
-
If further movement is detected subsequently, the light is switched on again if there is insufficient
brightness.
Detector is blocked:
-
The central command is not executed.
