The application programme "thePixa P360 KNX"
Optical presence detector thePixa P360 KNX
34
Designation
Values
Description
Activate security mode
no
In thePixa Plug app, the available
parameters can be changed without a
password:
- Entering actual temperature
- Light level value per zone
- Installation height
- Detection sensitivity
- Teach-in
- Factory settings
- Firmware update
- Zone editing
yes..
To adjust the parameters listed above,
the security password must always be
entered.
The safety mode can also be activated
subsequently in thePixa Plug app.
Security password
free text entry
(6 characters)
The parameter is visible if "yes.." has
been set at the parameter <Activate
security mode>.
Security password to allow the settings
in safety mode to be changed via
thePixa Plug app.
The security password must consist of
6 characters; A-Z, 0-9
The security password can also be
assigned later in thePixa Plug app.
Room definition
standard
meeting room
Standard room, e.g. office, corridor, etc.
The detector is installed in a meeting
room. Therefore, the detection
algorithm is adapted to these
conditions.
The focus is on counting persons.
The meeting room mode may only be
used for a respective meeting room.
Important: The room definition refers
to all zones.
Send temperature on bus
no
The measured temperature value is not
transmitted.
The measured temperature value is
transmitted on the bus.
A temperature calibration made in
thePixa Plug app is taken into account
when the value is output.
yes..
1
Note: The security password can be changed at any time in the ETS or in thePixa Plug app.
