TESTO 0555 6383, Инструкция по эксплуатации

Страница: 35 / 76

4 Transmitter
35
3. Accept setting by pressing SET and test with multimeter
(minimum requirement: resolution 6.5 digits, at least 2-times
more accurate than the 6383) as follows:
Analog output 1: Via test contacts under service flap, see
diagram.
1 Channel 1
test contacts
2 Service
interface
3 Multimeter
4. Return to Test Analog Output with ESC and use

or

to
continue to Test Relay Output .
Testing functionality of the pressure sensor ( Test pressure
sensor )
This function is only required to calibrate the pressure
sensor.
Testing functionality of relay outputs
1. Press SET and choose between Alarm 1, 2, 3, 4 with  or  .
2. Press SET .
The relay can now be tested. You can choose between OFF
and ON using

or

. If ON is chosen, the NO contact is
closed, the NC contact opened. If OFF is chosen, the NC
contact is closed, the NO contact opened.
3. To test, route a measuring cable from the relay terminals (see
Connecting the relay outputs, page 19 ) out of the transmitter to
a multimeter (resistance measurement) or continuity tester.
4. Return to Test Relay Output with SET (starts relay test) or
ESC (exits the menu without relay test).
Reading off min./max. values of channels
To reset the max./min. values, see Editing Reset main menu, page
39
1.
Read off the min./max. values of the channel in succession with

or

and return to the Main Menu Analysis with ESC .