TESTO 0555 6383, Инструкция по эксплуатации

Страница: 34 / 76

4 Transmitter
34
Editing code settings
You can set the access code (password).
If a code other than "0000" (factory setting) is set, the
transmitter can only be operated once this code has been
entered via the menu.
1. Select Code with  or  and confirm selection with SET .
2. Scroll one digit to the right using

and increase value of digit
by 1 using  . Confirm with SET or abort entry with ESC .
3. Return to Code with ESC and use  or  to continue to
Change parameters .
Select unit (Change unit)
This setting affects the displayed unit of all readings.
1.
Press SET , select Change parameters with  or  , confirm
selection with SET or cancel with ESC .
2. Select Change unit with  or  , confirm selection with SET or
cancel with ESC .
3. Select the required variable (absolute pressure/temperature)
with
 or  , confirm selection with SET or cancel with ESC .
4. Select the required unit with  or  , confirm selection with SET
or cancel with ESC .
5 Return to Change unit with ESC .
6. Return to Change parameters with ESC .
7. Return to Main Menu Settings with ESC .
Pos: 56 /TD/Produkt verwenden/MUF 63xx/Hauptmenü Analyse bearbeiten 635x @ 3\mod_1237277461094_79.docx @ 29753 @ 45555 @ 1
4.4.5.4. Editing Main Menu Analysis
You can test the functionality of analog and relay outputs. In
addition, you can read off the minimum and maximum values (since
the last voltage supply or reset of the min./max. values).
Testing functionality of analog outputs
This function affects the analog outputs directly, not only
the test contacts.
1. In the Measuring Mode press SET , select Main Menu Analysis
with  or  and confirm selection with SET .
- Test Analog Output is shown.
2. Press SET , scroll one digit to the right using  and increase
value of digit by 1 using

. Any analog output value can be
predefined, e.g. for an analog output of 4 to 20 mA, the value
"6.0 mA". Confirm with
SET or abort entry with ESC .