Teltonika FMB630, Руководство пользователя

Страница: 45 / 173

45
Figure 37 FMB630 Features->Trip Configuration
If I/O Trip Odometer is enabled and Odometer Trip Mode distance counting variable is set
to Continuous, Trip distance is going to be counted continuously (from Trip start to Trip stop).
This value is written to I/O Odometer value field. When Trip is over and next Trip begins,
Odometer Trip value is reset to zero, and it is counted continuously again.
If I/O Trip Odometer is enabled and Continuous Distance Counting variable is set to
“Between Records”, then distance is going to be counted only between every record made. This
value is written to I/O Trip Odometer value field and reset to zero every new record until Trip
stops. If later all Odometer values are summed up manually user gets distance driven over the
whole Trip period.
When trip is enabled and Remember iButton ID in trip settings is also enabled, device will
remember iButton (during trip) when it is attached. Ibutton value will lose after reset. When
iButton value is saved, it will be stored in iButton I/O and will be added with every record. When
new iButton is attached, its ID will be added to iButton I/O and old iButton value will be
forgotten. When iButton is attached and ignition is not ON, then iButton is saved but value will
not be added to I/O. If iButton is not attached in Ignition OFF timeout, then iButton value is
removed. It is added only when ignition is set on and trip event occurred. The iButton is removed
from iButton IO (set to 0) when trip end event occurs.
6.3.6.4 Geofencing
Geofencing settings:
FMB630 has 20 configurable Geofence zones and it can generate event when defined
Geofence zone border has been crossed. Or overspeeding is occured in a configured geofence
zone.