Teltonika FM6320, Руководство пользователя

Страница: 26 / 139

26
5
OPERATIONAL BASICS
5.1 Operational principles
FM6320 module is designed to acquire records and send them to server. Records contain
GPS and I/O information. Module uses GPS receiver to acquire GPS data and is powered with 3
data acquire methods: time-based, distance-based and angle-based. Method’s details are
described in Data Acquisition
chapter 8. All data is stored in flash memory and later can be sent
via GPRS/3G or SMS channels. GPRS/3G mode is the most preferred data sending mode. SMS
mode is mostly used in areas without GPRS/3G coverage or when GPRS usage is too expensive.
GPRS/3G and SMS settings are described in chapters 6.3.3.2.1 and 6.3.3.2.3. FM6320
communicates with server using special data protocol. Data protocol is described in device
protocols documentation. Please contact Teltonika sale manager to find out more about
protocols documentation purchase.
FM6320 can be managed by SMS commands (SMS Command list is described in SMS
Command List section) and GPRS commands (GPRS Command list is described in GPRS Command
List section)
. Module configuration can be performed over TCP or via SMS. Configuration
parameters and modes are described in device protocols documentation.
5.2 Operational Modes
FM6320 is designed to operate in two different modes: Normal Mode and Deep Sleep
Mode (Standby mode). Normal Mode means that FM6320 is fully functional and performs all the
functionality mentioned above in Operational principals section.
Deep Sleep Mode is designed to dramatically reduce power consumption. It is a separate
mode and certain conditions must be fulfilled to switch from Normal operation and enter this
mode. Detailed information about how FM6320 enters/exits Deep Sleep Mode and what
functions does FM6320 perform while in this mode can be found in chapter 10.
5.3 Accelerometer
FM6320 has a built in 3 axis accelerometer which allows the device to indicate if vehicle is
moving or not, as well as measure acceleration. Accelerometer sensitivity can be configured – it
has 2 configurable global parameters: start and stop timeouts that define time intervals in
seconds. To indicate that a vehicle is moving, FM6320 constantly (in frequency of 50 Hz) checks
for g force change on X, Y and Z axes. If measured g force keeps exceeding the set limit (it is not
configurable) for defined time interval in “Movement Filter Start” field (Figure 10), then the
vehicle is considered as moving. Same settings for idle indication apply – if g force change is less
than the set limit for time interval defined in “Movement Filter Stop” field then the vehicle is
considered as idle (not moving).
Example for default parameters: Movement Filter Start = 1 and Movement Filter Stop = 30
means that movement will be detected after 1 second and stop will be detected after 30 seconds
of inactivity.