Teledyne ACCQPrep HP125, Инструкция по установке и эксплуатации

Страница: 28 / 142

ACCQPrep HP125
Section 2 Installation
2-12
Figure 2-18 Z-Drive rotation
6. Mount the wash well by placing it into the receptacle
located on the right-rear portion of the AutoSampler Mod-
ule bed (Figure 2-19).
Figure 2-19 AutoSampler Module wash well with tubing attached (top tube is waste to port #2 while
the bottom tube is supply port #3)
7. The wash well comes pre-plumbed to the peristaltic pump
ports. If disconnected in the future, it is important to con-
nect the wash well waste tube (upper tube on wash well
labeled 2) to port “2” of the peristaltic pump and connect
the wash well supply tube (lower tube on wash well labeled
3) to port 3 of the peristaltic pump.
8. Connect the tube labeled “Wash Supply” to the tube
labeled “1” connected to port “1” of the peristaltic pump on
the back of the Autosampler Module. The free end of the
tubing can be placed in the wash solution container or tee’d
into a solvent supply line (Figure 2-20).
Wash station
Overflow drain
Waste line
Wash station
supply line