Teledyne 3700, Инструкция по установке и эксплуатации

Страница: 49 / 242

3700 Portable Samplers
Section 3 Programming Guidelines
3-15
CAUTION
Tests indicate that the pump produces sound levels in excess
of 85db at one meter. Prolonged exposure to this sound level
could result in hearing loss and requires the use of protective
ear plugs.
• When you press the
STOP
key, the sampler will display a
message similar to the one shown below . This message
indicates the total number of pump counts that occurred
while the pump was running. This information can be
used to set the desired number of purge counts required
to purge the suction line. See the
Purge Counts configure
option. Press any key, except
STOP
and
ON
/
OFF
, to return
to the standby display..
•
STOP
- The
STOP
key will stop the pump any time it is
running. When you press the
STOP
key in the run state,
the sampling routine will halt, the sampler will transfer
to the standby state, and the “PROGRAM HALTED”
message will be displayed. Pressing the
STOP
key while
in the interactive state will access the display’s
reference number.
•
START SAMPLING
- When in the standby state,
pressing the
START SAMPLING
key will begin the
sampling program. When entering a sampler ID, this
key will type a space.
•
RESUME SAMPLING
- When “PROGRAM HALTED” is
displayed, pressing the
RESUME SAMPLING
key will cause
the sampler to continue with the current sample
program at the point were it was halted. When entering
a sampler ID, this key will type a period.
•
MANUAL SAMPLE
- Pressing the
MANUAL SAMPLE
key
will allow you to take a manual sample. The
MANUAL
SAMPLE
key is valid in the standby state, the run state,
and when calibrating the sampler. If you press the
MANUAL SAMPLE
key while a sampling program is in
progress, the manual sample will be counted as one of
the programmed samples.
When entering a sampler ID, this key will type a dash
(-).
•
NEXT BOTTLE
- If you want to reposition the
distributor, use the
NEXT BOTTLE
key. The sampler will
advance the distributor to the next bottle position. (The
sampler determines the bottle positions by referring to
the Bottle Number configuration setting.) The sampler
will display the distributor’s location as illustrated in
g .
After a short time, the display will revert to standby. If
311 COUNTS FORWARD