TelcoBridges TSBC3000, Руководство по установке

Страница: 15 / 60

9
Installing the Equipment
2.2 Rack Mounting the TSBC3000 Series Standalone or the
TSBC3000 Series 1+1 System
The TSBC3000 series equipment is mounted on a customer provided equipment rack using the
mounting hardware packaged in the box.
2.2.1 Prerequisites
To rack mount the equipment, you will need:
• One 19” customer-provided equipment rack. The rack must be solidly anchored to the floor with
appropriate support at the top of the racks.
• Climate controlled room: 0 to +70 Celsius, 0 to 95% non-condensing humidity.
2.2.2 Vertical Placement of the Equipment
The TSBC3000 series standalone, TSBC3000 1, and 1+1 Patch Panel are each housed in a 1U
chassis, as tabulated in
table 2.2 on page 9. It is important that you provide for enough room on the
equipment rack to allow for the installation of the equipment.
Consider the available space on your equipment rack and the height of the TSBC3000 series
equipment. Due to the rear-exhaust heat vents and the efficient heat dissipation design, there is no
need to leave any physical vertical space above or below the TSBC3000 series equipment on the
equipment rack.
Note
The patch panel can be installed behind the TSBC3000 if the equipment rack is deep
enough. Doing so will simplify cabling.
Table 2.2 TSBC3000 Series Physical Height
Model Number Vertical Height
TSBC3000 series standalone 1U (1.75 inches or 44.45 mm)
TSBC3000 1 1U (1.75 inches or 44.45 mm)
Patch Panel (one or two) 1U (1.75 inches or 44.45 mm)