TelcoBridges TSBC3000, Руководство по установке

Страница: 20 / 60

TSBC3000 Series Standalone and TSBC3000 Series 1+1 System Installation Guide
14
2.4.1 Connecting to the TSBC3000 Series Management Interface
The TSBC3000 series provides management interface(s) enabling administrators to perform
management tasks on the TSBC3000 series unit.
Prerequisites
To communicate with the management interface, One or two CAT5 Ethernet cable with RJ45 male-male
terminations:
Interconnections
The TSBC3000-680 provides redundant management interfaces each using one gigabit Ethernet
network link, while the TSBC3000-2700 provides a single management interface. See
figure 2.2 on
page 14.
To communicate with the management interface:
1. Connect the supplied CAT5 Ethernet cable to the port labeled “MGMT0” at the rear of the
TSBC3000 series. Connect the other end of the same CAT5 cable to the first gigabit Ethernet
switch.
2. In the case of a TSBC3000-680, if your system employs a second gigabit Ethernet switch for
redundancy, connect a second CAT5 Ethernet cable to MGMT1 at the rear of the TSBC3000-680.
Connect the other end of the same CAT5 cable to the second gigabit Ethernet switch.
Figure 2.2 Management Interface
Note
The default IP addresses for the management ports are located in the “Important Notice”
sheet received with the shipment. For the TSBC3000-680, MGMT ports are configured in
bonding.
If you do not know the default IP address, go to Section 3.5 “Changing the TSBC3000
Series Management Port IP Address” on page 49.
Mana g ement Interface 1
Gi g abit
Ethernet Switch 2
15 14 13 12
10 11 8 9 3 2 0
7 6 5 4
1
MGMT0
MGMT1
ETH0
ETH1
VOIP0
VOIP1
Gi g abit
Ethernet Switch 1
Mana g ement Interface 2
MGMT0
ETH VOIP
0 1 0 1
TMS
0 1
TSBC3000-680
Mana g ement Interface
Gi g abit
Ethernet Switch 1
TSBC3000-2700