Troubleshooting
CSA8000 & TDS8000 Instruments and Sampling Modules
6–77
BIOS Error Messages
Table 6–7 lists error messages displayed by the BIOS.
Table 6–7: BIOS error messages
Error message
Explanation
GA20 Error
An error occurred with Gate-A20 when switching to protected mode
during the memory test.
Pri Master HDD Error
Pri Slave HDD Error
Sec Master HDD Error
Sec Slave HDD Error
Could not read sector from corresponding drive.
A: Drive Error
B: Drive Error
No response from diskette drive.
Cache Memory Error
An error occurred while testing L2 cache. Memory may be bad.
CMOS Battery Low
Replace the batter soon.
CMOS Display Type Wrong
The display type is different than what has been stored in CMOS.
Check Setup to make sure type is correct.
CMOS Checksum Bad
The CMOS checksum is incorrect. CMOS memory may have been
corrupted. Run Setup to reset values.
CMOS Settings Wrong
CMOS values are not the same as the last boot. These values
have either been corrupted or the battery has failed.
CMOS Date/Time Not Set
The time and/or date values stored in CMOS are invalid. Run
Setup to set correct values.
DMA Error
Error during read/write test of DMA controller.
FDC Failure
Error while trying to access diskette drive controller.
HDC Failure
Error while trying to access hard disk controller.
Update Failed
NVRAM was invalid but was unable to be updated.
Unlock Keyboard
The system keyboard lock is engaged. The system must be
unlocked to continue to boot.
Keyboard Error
Error in the keyboard connection. Make sure keyboard is
connected properly.
KB/Interface Error
Keyboard interface test failed.
Timer Error
Timer Test failed.
Memory Size Changed
Memory size has changed since the last boot. If no memory was
added or removed, then memory may be bad.
Serial presence detect (SPD) device data missing or iinconclusive.
Do you wish to boot at 100 MHz bus speed? [Y/N]
System memory does not appear to be SPD memory.
No Boot Device Available
System did not find a boot device.
Off Board Parity Error
A parity error occurred on an off-board card. This error is followed
by an address.
Содержание CSA8000 Series
