Tektronix 070-9778-03, Руководство по обслуживанию

Страница: 67 / 119

Maintenance
TLA 711 Color Benchtop Controller Service Manual
6–15
2. Carefully turn the subassembly over and connect the four SMB connectors
on the controller board. See Figure 6–7, and Table 6–4 for the color code
placement of the four SMB cable assemblies.
3. Carefully slide the subassembly into the chassis. Locate all of the front panel
connectors into the proper cut-outs on the front panel.
4. Connect the 8-pin power cable located at the rear of the module.
5. Secure the six screws that secure the subassembly to the chassis. DO NOT
tighten the screws until the front panel hardware has been secured.
6. Install the two flat head screws, located to the right of the PC Card slot.
7. Install the four standoffs on the SVGA OUT, and COM connectors.
8. Install the two screws on the LPT connector.
9. Tighten the six screws that secure the subassembly to the chassis.
Memory SIMMs
The memory SIMMs are located internally on the subassembly. Remove the
Benchtop Controller subassembly from the enclosure. Refer to the section on
Removing the Benchtop Controller Subassembly on page 6–12.
To remove the memory SIMMs, refer to Figure 6–6 and follow these steps:
1. Depress the tabs on each side of the SIMM.
2. Lift the memory SIMM out of the socket.
Removal