Tektronix 070-9778-03, Руководство по обслуживанию

Страница: 91 / 119

Troubleshooting
TLA 711 Color Benchtop Controller Service Manual
6–39
7. After installing the BIOS jumper, reassemble the controller module.
8. Reinstall the controller in the mainframe and reconnect all connectors
removed earlier.
9. Reconnect the power cord to the benchtop chassis.
The new BIOS requires you to change the CMOS BIOS settings. This only has to
be done once. To change the CMOS BIOS settings, follow these steps:
1. Insert the BIOS software floppy disk into the disk drive.
2. Power the instrument on. The floppy disk is a bootable floppy.
3. At the A:\> prompt, type phlash and press the Return key.
4. When the install program completes, press any key at the prompt.
5. Remove the floppy disk from the floppy disk drive.
Perform the following steps to configure the BIOS CMOS setup. You may want
to refer to the TLA 700 Series Installation Manual for a complete list of the
parameters for the CMOS setup.
1. Power the instrument off, and then on.
2. During the boot up process, press function key F2 to enter the CMOS Setup.
You may see a Checksum Error message. This is because you have not yet
configured the CMOS setup.
3. Select
Continue
from the menu to load the default values.
4. In the CMOS setup main menu select
IDE Adapter 0 Master
and then select
Autotype
for the hard disk drive type.
5. Enter the
Advanced
menu and scroll to the
Advanced Chipset Control
submenu
and select it by pressing the Return key.
a. Set the DRAM memory speed to 60 ns.
b. Press the Esc key to exit the Advanced Chipset Control submenu.
6. Select
Exit
and then select
Save
.
7. Continue with the regular boot up of the instrument.
8. Double-click on the
My Computer
icon.
9. Double-click on the
Control Panel
icon.
10. Double-click on the
Add New Hardware icon
.
Set Up And Update the
BIOS
Configure the CMOS
Setup and Complete the
Setup