Tektronix 070-9778-03, Руководство по обслуживанию

Страница: 40 / 119

Operating Information
2–6
TLA 711 Color Benchtop Controller Service Manual
The benchtop controller has one standard 2.5 inch IDE drive which interfaces
directly to the controller via an Enhanced Integrated Device Electronics (IDE)
extension of the PCI bus. The hard disk drive is available in two configurations: a
minimum configuration and a maximum configuration. The configurations
offered are subject to frequent change due to the fast-moving personal computer
component environment.
The benchtop controller has allocations for two 72-pin EDO DRAM memory
SIMMs. The SIMMs must be loaded symmetricly (in pairs), two SIMM
minimum (64-bits). The SIMMs speed requirement is 60 ns minimum.
Memory requirements are 16 MByte minimum configuration, or 32 MByte
maximum configuration.
Operating System and Application Interface
The benchtop controller ships with the Windows 95 operating system factory
installed. Operations and capabilities when running on the benchtop controller
are the same as with Windows 95 running on a high-performance personal
computer. Windows Help is available from the Start menu of the Windows 95
Task Bar. The Windows 95 software is included with the product. See the
software and the TLA 700 Series Installation Manual if you need to reinstall the
Windows 95 application.
The benchtop controller also comes with the TLA Series software application
that is configured at the factory to launch after the logic analyzer boots up and
Windows 95 is running. The TLA Series application is used to control data
acquisition and processing by the logic analyzer. The TLA Series application
software is included with the product. Refer to the TLA 700 Series Installation
Manual if you need to reinstall the TLA Series software application.
The topics that follow provide a brief overview of the TLA Series software
application. Refer to the online help and the TLA 700 Series Logic Analyzer
User Manual for additional information.
Hard Disk Drive
Memory SIMMs