Tektronix 070-9778-03, Руководство по обслуживанию

Страница: 60 / 119

Maintenance
6–8
TLA 711 Color Benchtop Controller Service Manual
Tools Required
Table 6–3 lists the tools needed to replace modules in the benchtop controller. All
tools required to remove and install each module are listed before the procedure.
Table 6–3: Tools required for module replacement
Item number Name Description
1 Torx-drive, torque screwdriver with a T-9 tip Standard tool
2 Small flat blade screwdriver Standard tool
3 #0 Phillips head screwdriver Standard tool
4 #1 Phillips head screwdriver Standard tool
5 Diagonal cutters (to remove cable ties) Standard tool
6 Soldering iron Standard tool
7 Solder wick or solder removing tool Standard tool
8 Three-sixteenth (3/16) inch nut driver Standard tool
9 Torx-drive screwdriver with a T-10 tip Standard tool
10 Needle nose plier Standard tool
Injector/Ejector Handles
You will need T-10 Torx tip driver (Table 6–3, item 9) to replace the ejector
handles.
Use this procedure and Figure 6–1 to remove the ejector handles.
NOTE
. The ejector labels can be replaced without removing the ejector handles.
Removal