Teeter FreeStep LT1, Инструкции по сборке и использованию, Страница: 7 / 24

5
Unpack and Prepare Your Workspace
• Follow the instructions on the outside of the box for the easiest unpacking process.
• If possible, assemble the equipment at or near the space in which you intend to use it to avoid moving it later.
• Unpack all parts and support materials. Set aside packing materials and clear your work area.
• Locate the Hardware Kits inside the box. They are labeled to correspond with the assembly process.
LET’S GET STARTED
FIGURE 4
ASSEMBLE REAR STABILIZER
STEP 1
Attach Rear Stabilizer
Figure 1: Remove the Base from the packaging and
position it on a level surface on the floor.
Remove the wooden plug from the Main Support Tube
in the back of the Base and set aside.
Lift the Base slightly from the back and insert the Rear
Stabilizer into the Main Support Tube at the back of the
Base.
TIP: The wooden plug can be used to prop up the base to
make inserting the screws into the Rear Stabilizer easier.
Step 1a Hardware
108
9
8
Bolt
Spring Washer
Washer
Lift
Insert
Figure 2:
Use the
Step 1a Hardware Kit
to attach the
Rear Stabilizer.
First hand tighten 6 × Bolts with 6 × Spring washers and
6 × Washers on the Rear Stabilizer Joint. The Spring
Washers should always be between the Bolt Head and
the Washer.
Use the Allen wrench to fully tighten each bolt.
Figure 2
Figure 1
NOTE:
Always hand tighten all the bolts or screws in each step before fully tightening with the wrench
or screwdriver. For reference, the Front, Back, Right and Left of the equipment is labeled on Page 3.
pending update potentially a specific order for tightening the handle screws
(pending arrival of new samples with adjusted holes that make the handles
open wider at the hips). Nick has asked the factory to hold off printing more
until further notice - once we confirm the handles work and we want to do that
screw order, then we’ll want to turn around an update for them to do a running
change.