- 21 -
HANDLING AND TRANSPORTATION
Handling must be performed by properly equipped personnel. If a fork-lift is used, pitchfork the machine in
the lower part using the appropriate ways in the wood bedplate. If a crane is used, for the heating section,
use the dedicated eyelets on the upper part of the heat exchanger as a coupling point; for the fan section use
the 4 threaded eyelets (included in the supply) previously fixed.
•
Use forklift forks, with a minimum length equal to the width of the machine.
•
Transportation and handling must be carried out with the utmost care, avoiding
damage to the appliance and danger to persons operating around the appliance.
•
During transportation and handling, it is forbidden to stand near the unit.
•
It is advisable to use personal safety equipment.
•
In order to prevent rainwater from entering the appliance, the plastic protection
should only be removed when the installation is complete (ducts, etc.).
•
If the device needs to be moved by hand, make sure that there is enough workforce
available in proportion with the weigh indicated in the section "DIMENSIONS AND
WEIGHT" and depending on the distance to cover.
•
If belts or ropes are used, a rocker arm must be used (not included) to prevent the
pressure exerted by the same from damaging the structure of the unit.
•
Should it be necessary to place more than one unit on top of each other, observe the
index indicated on the packaging itself and be very careful when aligning the
packages so as not to create unstable stacks.
