Technogym EXCITE Run 500, Руководство по техническому обслуживанию

Страница: 225 / 234

RUN EXCITE-2008: Service & Maintenance Manual - rev. 1.3
Page 11.3
11.3. MONTHLY MAINTENANCE OPERATIONS
These operations can be carried out by the machine owner and do not require any
special skills.
The monthly machine maintenance operations consists of simple cleaning, lubrication and
checking the state of wear to ensure the correct and safe functioning of the machine.
For the monthly maintenance of the machine, proceed as follows:
11.3.1. I
NTERNAL CLEANING OPERATIONS
1. Turn off the machine by placing the switch in position 0 (OFF).
2. Unplug the mains lead from the wall outlet.
3. Open the motor guard.
4. Use a vacuum cleaner to clean the interior, paying particular attention to the tread belt motor
and the electronic circuit boards.
WARNING: when carrying out these operations, be careful not to damage the cables.
5.
Move the machine and clean the floor underneath using a vacuum cleaner.
11.3.2. C
HECKING THE STATE OF WEAR
1. With the machine stopped, check the state of wear of the entire surface of the tread belt, turning
it by hand. If any anomalies are found, call in an authorized Technogym service technician.
11.3.3. C
HECKING THE OPERATION OF THE CARDIOTESTER RECEIVER
1. Using a separate heart rate monitor, put on the transmitter band and check that the machine and
the separate monitor both measure the same heart rate, and that when the band is disconnected
the machine does not receive any signal.
2. Using a heart rate frequency simulator, check that the machine detects the variations in the heart
rate.
11.3.4. C
HECKING THE OPERATION OF THE HAND SENSOR RECEIVER
Only on the 700 / 700E and 900 / 900E models.
1.
Using a separate heart rate monitor, grasp the hand sensors and check that the machine and the
separate monitor both measure the same heart rate, and that when the sensors are released the
machine does not receive any signal.