57
11
69
54
102
135
BAG E
21
q
1. Install the left rear Inner Pivot Block (54) by threading two
4-40 x 1/2" Flat Head Screws (135) through the bottom of the Chassis
(46) into the Pivot Block as indicated in Figure 49. Repeat for the right
rear Inner Pivot Block (55).
Figure 50A
q
1. Slide a inner Hinge Pin (102) through the holes in each of the
two rear Arms farthest away from the shock mounting hole.
Before you tighten the Main Block it may be necessary to
slightly loosen the Screws in the Inner Pivots about 1 full turn. Once
this is done, tighten the Main Block, followed by tightening the
Inner Pivots. This will ensure you get the correct Pin angle in the
Arms
q
2. Insert the right rear Arm (11) (Arms are labled "L" and "R")
into the left rear Inner Pivot Block (54). Repeat for the left rear Arm
(12) and capture the rear Arms by placing the rear Main Block (57)
onto the inner Hinge Pins as shown in the illustration in Figure 50B.
Secure the rear Main Block by threading two 4-40 x 1/2" Flat Head
Screws (135) through the Main Block into the upper holes in the rear
Diff Cover (69).
From this point on in the manual, when the rear Arms are
referred to, disregard the labeling on the Arm itself, and pay atten-
tion ot the location in referenc to the Chassis.
Figure 50B
Rear Arm Install
Step E-1
Rear Inner Pivot Install
Step E-2
135
46
54
135
Figure 49
102
135
ASSEMBLE MAIN BLOCK
IN THIS DIRECTION
