Taylor-Dunn ET-015-00, Руководство по эксплуатации, устранению неисправностей и замене запасных частей, Страница: 77 / 166

Motor Service
Motor
Page 5
REPLACING THE BRUSHES
NOTE: It is recommended that all four brushes be replaced as a set.
NOTE: Motors without removable brush covers must be disassembled
to replace the brushes. Refer to Motor Inspection-
Disassembly section for information on taking the motor apart.
NOTE: Some motors are equipped with brush pairs. These motors
must be disassembled to replace the brushes. Refer to
Motor
Inspection-Disassembly
section for information on taking
the motor apart. Refer to the
Motor Parts List
for your
vehicles brush configuration.
NOTE: Some motors have brush leads that are routed through or
behind the brush holder assembly. In this case, the brush holder
assembly must be removed to replace the brushes.
NOTE: The motor must be removed from the vehicle for this procedure.
Refer to
Transmission Service
section for information on
removing the motor.
1. Remove the brush covers.
2. Loosen the brush wire retaining screw and remove the brush from
the brush holder. Be careful with the brush spring and do not let it
slip off of the spring mount. If the spring comes off, then the motor
must be disassembled. Refer to
Motor Inspection-
Disassembly
section for information on taking the motor apart.
3. Install the new brushes in reverse order.
4. Be certain that the brush springs do not rest up against the brush
wires. Refer to illustrations in
Motor Inspection-Assembly
for
proper brush spring position.
Brush Spring Orientation