Taylor-Dunn ET-015-00, Руководство по эксплуатации, устранению неисправностей и замене запасных частей

Страница: 69 / 166

Maintenance, Service, and Repair
Brakes
Page 9
FLUSH THE BRAKE SYSTEM
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
6. Raise the front and rear wheels off of the ground and support with jack stands.
7. Release the park brake.
8. Remove the front and rear wheels. Refer to
Tires and Wheels
section for information regarding
removing the wheels.
9. Remove the wheel cylinders from each axle. Refer to
Replace the Wheel Cylinder
section for
information regarding removing the wheel cylinder.
10. Attach a clear hose to the bleeder valve on each of the wheel cylinders and route the hoses into a
container for waste brake fluid.
11. Position the wheel cylinders so that the bleeder screw is pointing to the ground and open all bleeder
screws.
12. Pump the master cylinder until all fluid has been pumped from the brake lines and all wheel cylinders.
13. Close all bleeder screws.
14. Fill the master cylinder with fluid.
15. Open one of the bleeder screws and pump the master cylinder until all fluid has been pumped from
the master cylinder and close the bleeder screw.
16. Repeat the above two steps for each wheel cylinder.
17. Reinstall the wheel cylinders and bleed the brakes. Refer to
Bleed the Brakes
for information
regarding bleeding the brakes.
18. Set the park brake.
19. Install the wheels and lower the vehicle to the ground.
20. Reconnect the main positive and negative cables at the batteries.
21. Release the park brake and test drive the vehicle.