Tascam DM-3200, Руководство пользователя

Страница: 82 / 120

6 – Effects : Setting up the effects
82
TASCAM DM-3200 User’s Manual
Use the cursor keys and
ENTER
to select an effect
from
PRESET 1
(TC Works reverb),
PRESET 2
(TAS-
CAM effect) or any of the four memory banks on the
CF card.
Use the wheel or PD 4 encoder to scroll through the
entries and press the POD 3 switch to recall the entry
to the effect loop.
Press the
EFFECT
key once more to return to the set-
ting screen:
The exact screen depends on the effect selected, as
explained below, but the top row is common to all
effects, whether TASCAM or TC Works:
TASCAM effect parameters
The TASCAM effects (chorus, de-esser, delay, dis-
tortion, exciter, flanger, guitar compressor, phaser,
pitch shifter, soft compressor) use the third row of
PODs as follows (display labels are shown in paren- theses in ( UPPERCASE )). When the basic effect is cho-
sen from the library, all on-screen controls change to
match those of the base effect:
Figure 6.3: Effect setting
POD 1 POD 2 POD 3 POD 4
INPUT type selection
(mono or stereo)
INPUT Sets the input level to
the effect MIX From dry (0%) to fully wet
(100%)
For guitar compressor,
distortion, compressor, exciter,
De-esser: Bypass — On or Off OUTPUT output level
Figure 6.4: Common effect parameters (Row 1)
POD 1 POD 2 POD3 POD 4
Chorus ( CHORUS )
Rate (RATE)
0.0 Hz – 10 Hz Depth (DEPTH)
0% – 100% Pre-delay (PRE DLY)
0.05 ms – 500 ms Feedback (FEEDBACK)
0% – 90%
De-esser ( DE-ESSOR )
— Threshold level (THRESHOLD)
–40 dB – –1 dB Knee shape (KNEE)
0.50 – 1.00 Center frequency (CNTR FREQ)
1.0 kHz – 10.0 kHz
Delay ( DELAY )
Delay time (DLY TIME)
0.05 ms – 650 ms Feedback time (FB.TIME)
0.05 ms – 650 ms Feedback level (FEEDBACK)
0% – 90% Feedback type (TYPE)
Stereo/Ping-pong/Multi-tap
Distortion ( DISTORTION ) a
– Drive ratio (DRV RATIO)
0 – 42 Drive boost (DRV BOOST)
x1 – x32 Drive EQ (DRV EQ)
Overdrive 1/Overdrive 2/
Distortion 1/Distortion 2/ Amp
1/Amp 2
Table 6.5: TASCAM effect parameters