TANDBERG E5780, Справочное руководство

Страница: 165 / 298

Operating the Equipment Locally — ATM Network Interface Option Module Menu
Reference Guide: evolution 5000 E5780 and E5782 Encoder Page 4-87
ST.RE.E10135.4
4.10.11 Incoming Calls Option
This enables the Incoming Calls to be changed.
Table 4.41: Incoming Calls Options
Selected Option Description
Permit All Accepts calls from any ATM address.
Refuse All No incoming calls accepted.
Authorisations Only accepts calls which are in the authorisations list.
4.10.12 General Menu
Table 4.42: General Menu Options
Selected Item Options Description
IP Address:
This is a network address
used to identify the ATM
interface when plugged into
an Ethernet network via the
10BaseT socket on the card. xxx.xxx.xxx.xxx Use the keypad to amend the IP Address.
IP NetMask xxx.xxx.xxx.xxx Use the keypad to amend the IP NetMask.
IP Gateway:
This option gives the default
gateway address used on
the Ethernet network
interface connected via the
10BaseT socket. Any communications to network hosts not on the local IP network will be sent
to this address.
Default ATM Prefix:
This option identifies the
ATM address prefix defined
by the connected ATM
network operator. 26 digit hexadecimal number This only needs to be specified if the ATM network does not support Integrated
Layer Management Interface (ILMI) which normally sets this prefix
automatically
UNI 3.0
UNI 3.1
UNI 4.0
Protocol versions used to communicate with the ATM network, defined by the
connected ATM network operator.
Def UNI Version:
This option is the default
User to Network Interface
(UNI) protocol version used
to communicate with the
ATM network, defined by the
connected ATM network
operator.
This only needs to be specified if the ATM network does not support ILMI, which normally automatically
negotiates the version to use. Use the softkeys to amend the Default UNI option.
TRUE When set to TRUE a new status parameter, Own ATM Address, appears in
the General menu. Enable SVC PMP:
This enables the Enable
SVC PMP to be changed.
FALSE
Own ATM Address
Software Release
Protocol Version
Hardware Release
TxFirmware Release
RxFirmware Release
These options are status only and cannot be changed.