TANDBERG E5780, Справочное руководство

Страница: 96 / 298

Operating the Equipment Locally — Setup Menu: Video Menu
Page 4-18 Reference Guide: evolution 5000 E5780 and E5782 Encoder
ST.RE.E10135.4
4.4.5 General Menu
Overview
The
General Menu
provides options for configuring the general parameters of the Encoder
such as the time and date, screen savers, and fan control. See Figure 4.4 for the
menu
structure and Table 4.6 for the option descriptions.
Path: Summary Screen [More]> Setup> System> General
Table 4.6: General Menu Options
Selected Item Options Description
Model Number:
The model number of the Encoder
is reported.
The model number of the Encoder cannot be changed.
Whilst the Encoder is initialising this value may be incorrect because all the
option cards may not have been identified yet.
Config Name:
Assign a name to the current
Encoder configuration.
It is this name that is used if the configuration is stored (see Section 4.14,
Configs Menu).
Local Time:
Sets the Encoder local time.
Local Date:
Sets the Encoder local date.
Min: –12 Hours
Max: 15 Hours
UTC Offset:
The Universal Time Co-ordinate
(UTC is effectively the same as
Greenwich Mean Time (GMT).
Step Size: 1
Hour
UTC offset. A positive value indicates East of Greenwich, and a negative value
indicates West of Greenwich. If the specified UTC offset is outside the valid
input range, a confirmation screen is displayed which shows the
minimum/maximum value allowed.
When including SI in the output transport stream the Encoder is required to
output a Time and Date Table (TDT). This uses UTC. Therefore, as the local
time is input on the front panel a UTC offset is needed so that the UTC time for
the TDT table is generated.
GPS UTC Offset:
0 to 60 The factory default is 13 (which is the current offset as of June 2005. The value
changes at irregular times, a few times a decade). This number is used to set
the GPS_UTC_Offset field in the ATSC STT table.
Temperature
The Temperature option indicates the current internal temperature.
Top-Level Menu
Van
Service Name
Screen Saver:
Set the Screen Saver.
Off
If no changes have been made to the Encoder for five minutes (no softkey has
been pressed) the chosen screen saver appears on the front panel display.
On A beep sounds every time that a front panel key is pressed.
Keypress Beep:
Set the Keypress Beep.
Off There is silence every time that a front panel key is pressed.
On The outputs are restored following a power dip.
Off The outputs are not restored following a power dip.
Power Dip Recovery:
Set the Power Dip Recovery.
It determines the state of the satellite modulator outputs (if fitted).
Upgrade Encoder:
Shows the box serial number.
The serial number is
in the range of 0 to
65535 There are a number of features which are not enabled by default. Refer to
Chapter 3, Options and Upgrades, Table 3.1 for details. These software
options must be purchased before a software licence key can be sent.
Send the serial number to TANDBERG Television Customer Services to obtain
a software licence key to enter via the front panel to enable the features.
Software Release
The software release cannot be changed.
Auto (Temp. control) The fans are activated automatically when a defined temperature is reached.
Fan Control
On The fans are activated all the time.