TANDBERG E5780, Справочное руководство

Страница: 141 / 298

Operating the Equipment Locally — Data Menu
Reference Guide: evolution 5000 E5780 and E5782 Encoder Page 4-63
ST.RE.E10135.4
4.7.4 Data C – Ethernet Menu
Table 4.21 shows the options for the Data`C – Ethernet Menu options.
NOTE…
If Ethernet data is turned on it is not possible to turn RS232 data on.
Table 4.21: Data C - Ethernet Menu Options
Selected Item Options Description
Licence Key: This option is only available if the M2/EOM2/EthernetData licence key is
purchased otherwise, packets arriving over the Ethernet are ignored.
It is only possible for the Encoder to accept either RS232 data or Ethernet
data.
On(BissKeys) Similar to On(TSPkt Data), additionally, aCA descriptor is placed in the CAT.
CA_System_ID=0x1001. The CA PID is set; there is no check that the PID
entered corresponds to the PID of the packets being received over Ethernet.
On(VRNav Data) The Encoder accepts data, as DCIIText messages containing VRNav data
packets, coming in as UDP datagrams on its Ethernet port.
The Encoder will packetise the data into Transport Packets and set TS header
bits – Packet Start is set for each TS packet containing the start of a DCIIText
packet.
On (TSPkt Data)
When selected, the Encoder expects pre-formed transport stream packets, one
per UDP packet.
Off
Encoding:
Delivery of packets is not guaranteed. The maximum data rate is 100 kbit/s.
It is only possible to turn this option on if RS232 data is turned off.
Port Number:
This is the IP Port number. 0 to 65535 The default is 1000.
PID: 0x0001 – 0x1FFE The default is 0x100.
The PID option is not relevant for On(TSPkt Data).
Pkts Received:
Shows the number of packets
received on the port.
Pkts Sent:
Shows the number of packets put
on to the transport stream.
Alarm Screen:
An Alarm is raised if Ethernet packets are discarded because the playout FIFO
is full i.e. if incoming rate is too high. The default is that this is NOT masked.